Flip/Flop....

Pulled the cockpit out, marked spots for backing plates (traveler, center block behind traveler, spinnaker blocks on aft decks, foot strap tie downs on aft cockpit sole....I think that is it), cleaned up front end of cockpit where it meets the cabin and flipped it back over again.

Here it is mid flip:

And here is the bottom...done!

I also gave the inside of the aft section a quick sanding and am debating about one more layer of epoxy to seal it all. I also need to add the backing plates for the pintels and gudgeons and an outboard. Other than that, I am ready to put this bad boy in for good!